DIY Tassel Garland Just in case a S’mores Bar isn’t already almost too fun to handle- we decided to spruce ours up with a fun DIY Tassel Garland! This easy and affordable DIY decoration can be added to a
In the bottom of the unit is a cover for a water pan
Remove cover and fill the water pan 2/3 full with water
Put lid back on
Put pretzels on Close Door
Set temp. to Approx. 140 degrees
Turn switch to ON
wait about 1⁄2 hour to 1 hour
Pretzels will be nice and moist and warm for several hours
ENJOY!
CLEANING:
Turn switch to OFF
Remove Pretzels
Wipe out with damp soft cloth (DO NOT use abrasive material and/or cleaners) Empty water pan
Cambro Beverage Dispenser Instructions
Cambro Beverage Dispenser
Loading Tips for Maximum Temperature Maintenance: NO pre-heating necessary
If you prefer to warm the container, use hot water only Do not use any electrical heat sources.
Fill each container as full as possible
Open vent cap
Keep open for two-three minutes for initial steam release when first loading hot foods.
Fill one compartment at a time
When it is full, move to the next compartment.
Fill, and then close, each container as rapidly as possible. Be sure lid gasket is in place before closing a container.
Care and Cleaning:
Clean regularly using a mild detergent and a soft brush (Hand wash only) Dry with soft cloth only (Do not use abrasive materials and/or cleaners)
Fog Machine Instructions
Insert remote control into rear of machine.
To avoid risk of electric shock, insert line cord plug into grounded outlet only.
Fill reservoir with water based fog fluid.
Close cap tightly. Push clear plastic feeder tube down through cap (if there is slack)
When indicator light goes off (or goes on if it was off) the machine is ready for use.
At times the indicator will come on (or off if it was on) this is normal, the machine is simply recycling. Depress the switch only when light is OFF (or on if it was off).
To use timer mode, press “timer” button.
Adjust “duration” knob for length of fog burst.
Adjust “interval” knob for length of time between fog burst.
Allow fog machine to cool down before packing for transportation
*IMPORTANT* -Always make sure that there is enough fog fluid in the tank before turning the fog machine on. Activating the pump without fluid can cause damage to the pump and heat core.